Screwlock - 50ml - A2222

Price for 1 unit: £13.14
Ex. VAT: £10.95
Product Datasheet:
Download PDF

Not sure this is the right adhesive for your requirements?

Please contact our friendly team for some free advice about your individual requirements.

Product Overview

Screwlock A2222 is designed for the sealing and locking of threaded fasteners which may require easy disassembly with standard hand tools.

This adhesive is a single-component anaerobic, low-strength thixotropic, acrylic-based threadlocker, and it cures when confined in the absence of air between close fitting metal surfaces, while preventing leakage and loosening from vibration and shock.

Cost of this Adhesive

If you buy this adhesive in bulk it is as cheap as £8.76 / bottle + VAT.

Adhesive resistance

This adhesive has very good chemical and solvent resistance in particular to:

  • Motor oil
  • Leaded petrol
  • Brake fluid
  • Acetone
  • Ethanol

Application uses

Screwlock A2222 is particularly suitable for uses such as:

  • Adjustment of set screws
  • Small diameter or long length fasteners where easy disassembly is required without shearing the screw
  • Sealing and locking of threaded fasteners

Technical information

Colour Purple
Base Dimethacrylate ester
Fluorescence Positive under UV
Fluorescence Positive under UV
Fixture Time 15 mins
Specific Gravity (25°C) 1.05
Cure Anaerobic
Viscosity 1200-1500 cps

Typical Performance of Cured Material

Operating temperature (After 24hr at 20°C - 25°C on M10 steel nuts and bolts) -54°C to 150°C
Breakaway torque M10 steel bolts and nuts ISO 10964 8 Nm
Prevail torque M10 steel bolts and nuts ISO 10964 6 Nm

How to use this adhesive

Please follow these steps when using this adhesive fluid.

  • For optimum performance surfaces should be clean and free of grease (internal and external)
  • If the material is an inactive metal consider using activator
  • Shake the product thoroughly before use
  • Apply several drops to the bolt and nut
  • Assemble and tighten as required
  • To prevent the clogging of the nozzle, do not let the tip touch metal surface during application

Disassembly information

  • Remove with standard hand tools
  • In circumstances where hand tools do not work, use localized heat to bolt or nut, disassemble while hot

Cleaning information

To remove cured adhesive use a combination of solvent and abrasion such as a wire brush

Not sure if this screw lock adhesive is right for your requirements?

If you are not sure if this adhesive is correct for your requirements please contact us to discuss your requirements and we can point you in the right direction.


01143951004 01152000565 01214616076 01332482732 02477350519